Contact Us

Contact: Monica

Mob: +86-18261516116

E-mail: Sales7@cnboly.com
Address: No.9 Xinda Road, Zhutang Town, Jiangyin City, Jiangsu Province, China

Home > Knowledge > Content
How to use shredder safely
Jan 16, 2018

(1) Shredder should be fixed on the cement foundation. If you frequently change locations, shredders and motors should be mounted on a stand made of angle steel.

(2) After installing the grinder to check the fastening of the various components, at the same time to check the tightness of the belt is appropriate, the motor shaft and grinder shaft parallel.

(3) Before starting the mill, turn the rotor by hand to check whether the operation is flexible and normal, whether there is a collision phenomenon in the case, whether the rotor's rotation direction is correct, whether the motor and the pulverizer are lubricated well or not.

(4) Do not replace the pulley, in case the speed is too high or too low.

(5) After the start of the mill should be idling for 2-3 minutes, no abnormalities before feeding work.

(6) feeding should be uniform, if there is noise, bearings and the body temperature is too high or spray out the phenomenon of the phenomenon should be immediately shut down to check and troubleshoot.

(7) carefully check the material, so as not to metal, stones and other hard objects into the crushing chamber caused an accident.

(8) Feeding, the staff should stand on the side of the grinder to prevent debris from bouncing back the face. When smashing long stems can not grasp too tightly to prevent the hand was brought.

(9) stop before stopping feeding, the material in the standby to be excluded after clean, then cut off the power down. Shut down after cleaning and maintenance.

(10) Mill 300 hours after operation, to be cleaned bearings, oil change; installed oil to full bearing clearance of 1/3 as well, up to not more than 1/2. Long time down, you should remove the drive belt.


Previous: Grinder maintenance ​

Next: No Information