The connecting parts of the motor, reducer, hydraulic coupling, head and tail of the food grinder must be complete, intact and fastened. There should be no oil leakage or oil leakage in the shaft joints of the reducer and hydraulic unit, and the oil quantity should be appropriate. The signal of the food grinder must be sensitive and reliable. No signal is not allowed to be turned on, and the spray and sprinkler device must be intact.
Food pulverizer is to pulverize large-size solid raw materials to the required mechanical size. The crushing and fine crushing of the mill is achieved by the pneumatic conveyor and high-speed collision. Using wind energy to turn into powder at one time, eliminating the traditional screening process.
How to install the food grinder
1. Preparation before installation
(1) The process should be determined according to the use occasion and some drawings, etc., and it should be suitable.
(2) Sufficient space should be left around the crushing equipment to enable feeding and maintenance work.
(3) The equipment foundation should be firm and strong enough, so that the main engine and motor can be installed smoothly.
Installation of food grinder
(1) General pulverizing equipment does not need to be balanced during installation, because its products have been carried out before they leave the factory.
(2) The necessary inspections should be carried out before the equipment is installed, and any problems should be dealt with in time.
(3) Check the wiring of the equipment and check whether the rotation direction of the motor is correct.
(4) Install as required. After installation, manually turn the rotor to check whether it rotates flexibly.
The head of the scraper conveyor on the working surface of the food crusher and the tail of the transfer machine should be properly overlapped; the scraper chain plate of the food crusher must be moderate, and the scraper and screws must be fully fastened; the walking trolley of the food crusher transfer machine must be stable and reliable ; When the food grinder is turned on under the partial condition of the bridge body of the reprinting machine, the operation of the various parts should be no abnormal noise, the scraper, chain, and connecting ring should be free from twisting, twisting, or bending, and the roadway support must be intact and firm.
https://www.bolymill.com/