The discharge of the V-type mixer adopts a rotary valve and a fast screw cap

After the V-type mixer runs for the first time for 12 hours, a comprehensive inspection should be done to check the degree of tension of the V-belt.When the V-belt is evenly tightened when the tension screw is adjusted, the locking bolts of the motor seat plate must be tightened to prevent loosening. Check whether the inner wall of the mixing vessel and the discharge hole are clean, and timely cleaning should be done. The inner wall and the discharge part of the equipment should be smeared with anti-rust grease if the equipment is not used for a long time. The manufacturer should perform regular maintenance of the mixer, which is easy to damage and break Components and parts must be repaired and replaced in time. Electrical equipment should be regularly inspected, especially motors and heaters. If damage is found, they should be replaced in time. The electrical control box should be cleaned regularly, and the dust on the electrical components should be cleaned in time to prevent contactor contacts. damage.

The inside and outside of the hopper must be cleaned to replace the varieties of the V-type mixer. It is suitable for mixing powder or granular materials in the chemical, food, pharmaceutical, feed, ceramic, metallurgical and other industries. The machine has a reasonable structure, simple operation, and operation It is airtight and easy to feed in and out. The cylinder body is made of stainless steel, which is easy to clean. It is one of the common basic equipment of enterprises. Before starting up, check whether the electrical appliances are normal and whether the cover of the mixing cylinder is tightly closed. First plug in the power, and then turn on the switch, the machine will start. If the material is mixed, if the discharge port is not in your desired position, then you must inching until the discharge port stops at your desired position.

The method of using the V-shaped mixer is to first open the feeding port of the mixer under the condition of running with materials, and confirm whether the discharge port is closed or not, and put the specified amount of material into the V-shaped hopper according to the process control requirements. The feeding is completed, In order to prevent the material from flowing out during mixing, the feeding port must be closed and locked. The cylinder of this series of V-type mixers has no dead corners, no accumulation of materials, and short mixing time. The cylinder is made of stainless steel, the inner and outer walls are polished, and the outer Beautiful shape and easy to clean. The feed can be manually fed or vacuum suction, and the discharge adopts a rotary valve and fast screw cap. Equipped with a timer, the mixing time can be adjusted at will. Low noise and no vibration.

https://www.bolymill.com/