How to maintain a swing granulator

1. Daily Maintenance
Cleaning: After each use, the residual materials on the surface and inside of the equipment should be cleaned in time. You can use a soft cloth or brush to wipe the surface of the equipment. For parts that are difficult to clean, you can use compressed air to blow. Clean the screen regularly to prevent the screen from being blocked and affecting the granulation effect. The screen can be removed, rinsed with clean water or brushed with a brush, and then installed back after drying.
Check fasteners: Regularly check whether the fasteners of various parts of the equipment are loose, especially the connection between the rotating drum and the machine base, the connection between the motor and the reducer, etc. If there is any looseness, tighten it in time. Check whether the tension of the belt is appropriate. Too loose or too tight will affect the normal operation of the equipment. The tension of the belt can be adjusted by adjusting the position of the pulley.
Lubrication: Regularly lubricate and maintain the transmission parts of the equipment, such as reducers, bearings, etc. According to the instruction manual of the equipment, select appropriate lubricating oil or grease, and fill it according to the prescribed time and method. Pay attention to the level and quality of the lubricating oil, and add or replace the lubricating oil in time.

2. Regular Maintenance
Motor maintenance: Regularly check the operation of the motor, including temperature, noise, vibration, etc. If there is any abnormality, stop the machine for inspection in time, find out the cause and deal with it. Clean the cooling fan and vents of the motor to ensure good heat dissipation of the motor to avoid damage due to overheating. Perform regular maintenance according to the instruction manual of the motor, such as replacing wearing parts such as bearings and brushes.
Reducer maintenance: Check the oil level and oil quality of the reducer, and regularly replace the lubricating oil of the reducer. Different types of reducers have different requirements for lubricating oil, and the appropriate lubricating oil should be selected according to the instructions. Observe the operation of the reducer to see if there is abnormal noise, vibration or oil leakage. If there is any problem, stop the machine for inspection and repair.
Drum and screen maintenance: Regularly check the wear of the drum and screen. If there is a severely worn part, it should be replaced in time. Check the balance of the drum. If there is any imbalance, it should be adjusted in time. Balance can be achieved by adding a balance block to the drum or adjusting the installation position of the drum.
Electrical system maintenance: Regularly check the electrical system of the equipment, including wires, cables, switches, contactors, etc., to see if they are normal. If there is aging, damage or poor contact, it should be replaced or repaired in time. Check whether the grounding of the electrical system is good to ensure the safe operation of the equipment.

3. Precautions
Safe operation: When performing maintenance and servicing, you must strictly abide by the operating procedures to ensure personal safety. Maintenance and servicing work must not be carried out when the equipment is running.
Professional maintenance: For some complex faults or situations where important parts need to be replaced, professional maintenance personnel should be asked to perform repairs to avoid greater losses due to improper operation.
Spare parts management: Establish a spare parts management system and reserve some commonly used wearing parts so that they can be replaced in time when needed to reduce equipment downtime.
Record maintenance: Record each maintenance and servicing work, including maintenance time, maintenance content, replaced parts, etc., so as to facilitate future inquiries and analysis of the operation of the equipment.

In short, careful maintenance of the swing granulator is the key to ensuring its continued efficient operation and extending its service life. If you have any questions about the maintenance and servicing of the swing granulator, please contact Baoli Machinery Manufacturin, our professional team will provide you with tailor-made solutions and comprehensive technical support.

https://www.bolymill.com/