What are the inspection work before the debugging of the ultrafine pulverizer
May 16, 2022
The pulverizer is an essential equipment for the production of modern traditional Chinese medicine powder. It not only saves the time of manual operation, but also can complete the work of pulverizing and breaking walls faster. Today, with the rapid development of science and technology, we see that machinery and equipment are constantly being upgraded. With the advent of intelligence, more and more fully automated equipment appears in manufacturers.
1. For newly installed equipment, foreign objects such as iron lumps, electrode tips, welding slag, etc. will inevitably remain when the equipment is in place and the to-be-shredded bin is connected. Without turning on the fan and main motor, open the impurity-removing baffle below the feeding port, so that the impurities and washing materials can be discharged from here. After the end, open the observation door of the ultrafine pulverizer to check whether there are impurities in the pulverizing disc, and whether there is a hidden danger of collision between the hammer knife and the ring gear.
2. Check and set the parameters of the two frequency converters of the feeding motor and the grading wheel motor of the ultrafine pulverizer, and check whether the adjustment of the air circuit breaker, contactor, thermal relay and overcurrent relay corresponding to the motor is appropriate? Re-tighten the primary line all over again.
3. Check whether there is air leakage from the air shutoff device under the brake. You can place it by hand or fine powder at the interface to see if it feels sucked in. If necessary, it must be sealed. After all the above inspections are normal, prepare for production with material.
4. Whenever the rotating speed of the classification wheel decreases, the current of the main machine will also decrease. At this time, the feeding frequency can be gradually increased to increase the crushing output.
5. At the same time, adjust the opening range of the air door of the high-pressure fan, and detect the current of the high-pressure fan, so as to ensure a certain air volume and make the fan work normally for a long time.
6. If the output and fineness cannot meet the requirements due to material differences, the rotation direction of the grading wheel can also be the same as the rotation direction of the main engine, and other debugging methods are the same as above.
https://www.bolymill.com/


