Do you know the characteristics of ultrafine pulverizers?

For the special product of traditional Chinese medicine, there are three different crushing areas in the crushing chamber, which can adapt to the powder of various types of materials. The structure of the crushing zone is special, and the crushing particle size is fine. Because, the kinetic energy of the crushing zone is smaller than that of the second crushing zone. The gap between the teeth and the pulverizing tool is also from large to small; the pulverizing tool is movable to fixed. Therefore, the crushing process is the process of pre-crushing - strong crushing - fine crushing. At the same time, each pulverizing area partition plate has a certain angle with the pulverizing area, which has a certain blocking effect on the pulverized material, which is beneficial to the pulverizing effect.

Due to the relative separation between the pulverizing chamber and the grading chamber, the pulverized materials will not stay in the pulverizing chamber for a long time due to the obstruction of the grading wheel, avoiding the phenomenon of "over-pulverization". Thereby increasing the crushing capacity. Ultrafine pulverizer - uniquely designed grading chamber and grading wheel, uniquely designed grading chamber and variable frequency speed-regulated vertical grading wheel, no need to configure sieves, and the product particle size can be classified at low speed ;The cyclic feeding structure not only strictly limits the "large particles" but also avoids over-grinding, so the product has a narrow particle size distribution and uniform particle size; the classification wheel is adopted to avoid the phenomenon that the powder above 150 mesh is difficult to sieve.

Because the phenomenon of "over-crushing" is avoided. The crushing chamber does not generate excess heat. At the same time, an air duct is set at the feed end of the crushing chamber. Due to the existence of the induced wind, the temperature generated during the crushing is taken away by the induced wind, and a circulating water jacket device is added to the outer casing of the crushing to further reduce the temperature generated by the crushing. Fully enclosed negative pressure operation, no leakage of powder occurs during the crushing process, no environmental pollution, low noise; rounded corner design, quick-connection, easy disassembly and installation, easy to clean. It is especially suitable for reasonable configuration with the TC series ultrafine pulverizing classifier and TP series coarse pulverizing machine produced by our company to form a traditional Chinese medicine pulverizing workshop that meets the requirements of GMP.

https://www.bolymill.com/